网上赌场网址多少

How to replace the oil seal of a rotary cylinder

hit count: Updated: 18/05/25 11:24:05 Source: avervenus.com [ close ] share:
    The oil seal on the rotating oil cylinder is a mechanical element used to seal the grease. It isolates the parts that need to be lubricated from the power output parts in the transmission parts, so as not to leak the lubricant. So how to replace the oil seal if something goes wrong? Here's how to replace the oil seal:
    1. Obtain a fixed number of oil seals.
    2, from the oil seal to the assembly, must be kept clean.
    3. Before assembly, do oil seal inspection.
    4. Do machining inspection procedures before assembly.
    5, in the operation skills, you can feel it with your hands, whether it is smooth and round.
    6. Don't tear the packing paper too early before installing the oil seal to prevent debris from adhering to the surface of the oil seal and bringing it into work.
    7. Before installation, the oil seal should be smeared with a lithium ester with molybdenum disulfide added between the lips to prevent the shaft from starting instantly.
    8. The oil seal must be installed in a flat position without tilting.
    9, for the oil seal machine installed this time, mark to facilitate tracking, pay attention to the entire process. For transitional installation on a stepped shaft, the copper skin should be over-guided or protected with plastic tape to avoid damage to the oil seal.
    The above is the introduction of the oil seal replacement method. I hope that this problem can help everyone to replace the oil seal safely and quickly.
    Navigation

    contact us

    Weihai Kate Hydraulic Technology Co., Ltd. Address: Dongjing Road, Huancui District, Weihai City, Shandong Province Contact: Wang Hongyi
    Phone: 0631-5789884
    Fax: 0631-5789884
    Email: weihaikaite@163.com
    Main products: swing cylinder, rotary cylinder